Computer Systems Division Computer Hardware Service and Reference Manual
Table Of Contents
- Proprietary Notice
- Contents
- Preface
- Abbreviations
- Technical Information
- Utilities
- Option Installation
- Maintenance and Troubleshooting
- Disassembly and Reassembly
- Desktop -Illustrated Parts Breakdown
- MiniTower -Illustrated Parts Breakdown
- System Specifications
- Connector Pin Assignments
- System Resources
- Index
- FCC Statement
- Battery Replacement
Option Installation 3-25
External Options
External connectors on the back of the system unit allow for a variety of
industry-standard options
This subsection provides the installation procedures for the most commonly
used external options, which are as follows:
parallel printer
serial device.
For other external devices, see the instructions that come with the option.
Parallel Printer
Note:
Before connecting a printer to the system, be
sure the printer is set up correctly. Follow the setup
instructions that come with the printer.
Connect a parallel printer to the system as follows.
1. Turn off power to the system and printer.
2. Connect the printer cable to the printer port on the rear of the system unit
(see the following figure).
3. Secure the cable with the screws provided.
4. Connect the other end to the printer.
5. Turn on the printer and the computer.
Locating the Parallel Port
A
– Parallel Port