User's Guide

9-28 Upgrading Your Server
Removal
To remove the board, follow the procedure below:
1. Shutdown the CPU blade to be removed and turn off the power of the CPU blade.
2. Take the CPU blade out from the Blade Enclosure.
Refer to the User's Guide of the Blade Enclosure.
3. Put the CPU blade on an anti-static sheet with little dust.
4. Remove the five screws fixing the top cover.
5. Firmly hold the cover, move it slightly toward the rear of the blade, then lift the cover to
remove it from the CPU blade.
IMPORTANT: Handle the cover carefully so as not to make it contact
with any electronic components on the CPU blade.
6. Remove three screws fixing the mezzanine card.
7. Hold both ends of the mezzanine card and pull out the card from the slot.
Lift the card perpendicular to the CPU unit.
8. Install the top cover having been removed.
9. Secure the top cover with five screws.
10. Install the CPU blade having been removed to the Blade Enclosure according to the User's
Guide of the Blade Enclosure.
Type I
Type II