User's Guide

Installing the Operating System B-41
Setup Teaming
When the system is Windows Server 2008 64-bit (x64) Editions / 2008 32-bit (x86)
Editions
IMPORTANT:
 Teaming is not supported with Windows Server Core.
 SFT is not supported.
 Please confirm the port setting of switching hub (L2) matches the
server network adapter Teaming mode.
 AFT/ALB setting must be done after System Update completed and
PROSet install completed.
1. Open the [Device Manager].
2. Open [Network adapters] → [Intel(R)xxx] properties.
3. Click [Teaming] tab and check the [Team this adapter with other adapters] check box.
Click [New Team].
4. Fill the name of the team in [Specify a name for the team] and click [Next].
5. Include the adapter to the team and click [next].
6. Select a team type ([Adapter Fault Tolerance]/[Adaptive Load Balancing]).
Click [next].
7. Click [Finish].
8. Click [TEAM:"Team name"] from [Device manager] → [Network adapters] to modify the
team.
Click [Settings] tab and click [Modify Team] button.
9. Refer to the following procedure to set the team member adapter priority status.
– Set Primary
Point the adapter and click [Set Primary] button.
– Set Secondary
Point the adapter and click [Set Secondary] button.
NOTE: Adapter priority config can be confirmed by the following
procedure
1. Click [TEAM:"Team name"] from [Device manager] → [Network
adapters].
2. Click [Settings] and confirm Adapters in team list.