User manual

CHAPTER 5 FEATURE DESCRIPTION
NEAX 2000 IPS General Description Page 123
NDA-24345, Issue 3
Hotline - Inside/Outside
This feature causes the terminal to place a call to another station or to an outside party automatically
when the user selects the Hotline extension.
House Phone
This feature allows selected stations to reach the Attendant simply by going off-hook.
Individual Attendant Access
This feature permits a user to call a specific Attendant by dialing an Attendant call code.
Intercept Announcement
This feature provides the automatic interception of Direct Inward Dialing (DID) and Tie Line calls
which cannot be completed due to unassigned station or level. The caller hears a recorded Intercept
Announcement that informs the caller that an inoperative number was reached, and may supply the
number for information.
Intercom
Three types of Intercoms are available: Manual Intercom, Automatic Intercom, and Dial Intercom.
Each type of Intercom provides access to a small group of Multiline Terminals with simplified
calling methods.
Manual Intercom
The Manual Intercom groups have up to six Multiline Terminals sharing a common signal path.
Users can call other members of the Manual Intercom group by pressing a Manual Intercom key;
each press sends a tone burst over the speakers of all the terminals in the group. When another
user answers the call, a speech path is activated.
Automatic Intercom
Automatic Intercom provides a path for Voice Announcement Calls with Handsfree Answerback
between two Multiline Terminals using a line key. Private conversations can be held by using
the Multiline Terminal handsets. The Busy/Idle status of the associated Multiline Terminal is
displayed on the Automatic Intercom line key LED.
Dial Intercom
Dial Intercom comprises up to 10 Multiline Terminals which can call each other using a
dedicated Dial Intercom line key with abbreviated dialing. Dial Intercom calls can be Voice
Announce with Handsfree Answerback or ringing calls.
Internal Tone/Voice Signaling
Multiline Terminals can signal incoming internal calls by Voice Announcement or by ringing
according to the programmed mode (Voice first or Ring first) of the called terminal. The caller can
dial the digit 1 to change from Voice Announcement to Ring Tone or vice versa. The Multiline
Terminal assigned this feature can program the following two modes:
• Voice Mode: allows an incoming call to terminate with Voice Announcement.
• Tone Mode: allows an incoming call to terminate with ringing.
Internal Zone Paging with Meet-Me
This feature allows the Attendant Console and system users to page over the built-in speakers of the
Multiline Terminals within the assigned zone or all zones.