User manual

CHAPTER 5 FEATURE DESCRIPTION
NEAX 2000 IPS General Description Page 117
NDA-24345, Issue 3
Consultation Hold
This feature permits a station user to hold any incoming or outgoing CO call, tie line call, or any
intra-office call while originating a call to another station user within the system.
Customer Administration Terminal (CAT)
In addition to the Maintenance Administration Terminal (MAT), programming of the NEAX2000
IPS can be done from selected Multiline Terminals with LCD. The designated Multiline Terminals
can be placed in program mode, and system data can then be changed. To prevent unauthorized
changes, password levels are assigned, providing authorization for access to certain areas of
programming and denying access to others.
Data Line Security
This feature allows line circuits that are used for data transmission to be protected from interruptions
such as Attendant Camp-On, Executive Override, and Attendant Override.
Delayed Ringing
This feature enables trunks and station lines to ring immediately at the terminating station, but also,
after a programmable period of time has elapsed, to ring at secondary Multiline Terminals with that
trunk or line appearance.
Diagnostics
To assist maintenance personnel, the NEAX2000 IPS provides diagnostic capabilities such as fault
code generation, device status information and alarm information recording which can be accessed
from the Maintenance Administration Terminal (MAT) or Customer Administration Terminal
(CAT).
Dial by Name
This feature allows a Multiline Terminal user to search for a desired number by name. The number
and name are registered in the system and they are shown on Multiline Terminal LCD. The Multiline
Terminal user can search for the desired number by name using up or down soft keys. When the
Multiline Terminal user finds the desired number, the call can be originated by pressing the
Line/Trunk key or going off hook.
Dial Conversion
The system can be assigned to use rotary Dial Pulse (DP) or Dual Tone Multi-frequency (DTMF)
trunks and stations. This feature provides for the repeating of digits dialed by the station user onto
the C.O. trunks.
Direct Data Entry
This feature allows a maid or other hotel personnel to enter numeric data to the Property
Management System (PMS), using the guest room station for entry through dial operation. The same
numerical data can be output to a Hotel/Motel Printer by system data programming.
Direct Digital Interface
This service feature provides the capability to connect trunks from the NEAX2000 IPS directly to T1
carrier links using either a private or public network.
Direct Inward Dialing (DID)
This feature provides for incoming calls from the exchange network (except FX or WATS) to reach
any station within the system without attendant assistance.