User manual

CHAPTER 5 FEATURE DESCRIPTION
NEAX 2000 IPS General Description Page 111
NDA-24345, Issue 3
Background Music
Background Music can be provided on a dial-up basis over legacy Multiline Terminal speakers.
Incoming voice announcements, ringing and recalls override Background Music. Up to 10 music
programs can be offered.
Back Up CPU
NEAX 2000 IPS provides a dual CPU system with two MP cards. When Emergency Notification
from hardware is detected, the changeover from an active MP card to a standby MP card will occur.
If the active MP card becomes out of order for any reason, the standby MP card starts up
automatically. The standby MP card employs a Cold Standby System that will restart initialization
by the changeover from the active MP card.
Bandwidth Control
This feature allows assigning an available bandwidth threshold for VoIP Traffic within a location
and between locations, and to restrict Outgoing/Incoming Calls when the VoIP Traffic exceeds the
threshold. The location is a group of VoIP devices [IP Enabled Dterm, IP PAD, or Peer-to-Peer IP
Trunks (built-in IP Trunks)], that have the same VoIP communication parameter (such as CODEC
Selection List and ToS field) values assigned. When the VoIP Traffic over CCIS exceeds the
threshold, the call can be routed to Legacy Trunks (TDM Network). When exceeding the threshold,
the system can store fault information and provide external alarm indication.
Boss / Secretary Calling
A secretary with a Multiline Terminal can use an appearance of the boss' extension to screen calls for
that extension, and announce and/or transfer calls to that extension. Additionally, the secretary can
call the boss during a busy condition and send a Message Waiting Indication to the boss' station.
Broker's Call
This feature allows a Multiline Terminal or Single Line Telephone user to alternate between two
parties, talking to one party while the other party remains on Hold on the same line. The Multiline
Terminal user uses the TRF or ANS key to alternate between the two parties. The Single Line
Telephone user uses the Hold feature to alternate between the two parties.
Call Back
This feature allows a calling party to set an automatic Call Back when a busy or no answer condition
is encountered. When the busy station becomes idle, the station that set the Call Back will be called.
In case of Call Back no answer, the Call Back to the setting station is initiated immediately after the
called station goes on hook after making a call or accessing a feature.