User manual

CHAPTER 5 FEATURE DESCRIPTION
NEAX 2000 IPS General Description Page 105
NDA-24345, Issue 3
Chapter 5 Feature Description
Business/Hotel Motel Features
Account Code
This feature, when used with Station Message Detail Recording (SMDR), allows station users and
Attendants to enter a cost accounting or client billing code (up to 16 digits) into the system.
Add-On Module
This feature allows the Add-On Module to be combined with a Multiline Terminal when there are
insufficient line or trunk keys provided at the Multiline Terminal. When the Add-On Module unit
keys are programmed as line/trunk keys, the additional 25 lines/trunks and the existing lines/trunks
set for the Multiline Terminal can be accessed directly (maximum of 49 lines/trunks). The station
speed dialing function can be assigned for all keys on the Add-On Module unit. Also, one of the last
3 keys can be used as a Day/ Night change key.
Alarm Indications
Faults are indicated by the Major/Minor (MJ/MN) lamps located on the AC/DC Power Supply and,
optionally, an external alarm display unit. Station Application not applicable.
Alphanumeric Display
The LCD on Multiline Terminals is used to provide alphanumeric information including
clock/calendar and call processing information. Station Application All Multiline Terminals with an
LCD display.
Analog Port Adapter
This feature allows an Analog Port Adapter unit combined with a legacy Multiline Terminal to
connect to an analog terminal such as an analog telephone, Modem, and PC with built-in Modem.
There are two communication modes for the terminal connected via the Analog Port Adapter as
shown below:
1. Single Port Mode
A Multiline Terminal and an analog terminal share the same port. In this mode, the Multiline
Terminal and the analog terminal cannot be used simultaneously.
2. Dual Port Mode
A Multiline Terminal and an analog terminal use different ports. In this mode, the Multiline
Terminal and the analog terminal can be used simultaneously.
Announcement Service
This feature allows station users to record messages on Digital Announcement Trunk (DAT) cards.
When a station user dials the feature access code for this feature, the user receives the corresponding
message from the system. Also Announcement Service can be used to provide a voice message in
the following cases;
• An incoming C.O. line/Tie line call has been transferred and encounters a busy or no answer
condition
• An incoming DID line/Tie line call has been terminated to a station and encounters a busy or
no answer condition
• Internal Recorded Message in place of Music on Hold
• Night Announcement