Printer User Manual
Table Of Contents
- CONTENTS
- Ch1. Introduction
- Ch2. Setting-Up
- Ch3. Using the Printer
- Ch4. Printer Driver
- Introduction
- System Requirements
- Installing the PagePro 1100 Printer Driver Under Windows 95/Windows 98/ Windows NT 4.0
- Installing the PagePro 1100 Printer Driver Under Windows 3.1
- Displaying the PagePro 1100 Printer Driver Setup Dialog
- Using the PagePro 1100 Printer Driver Setup Dialog
- Uninstalling the Printer Driver
- DOS Printing Utilities
- Ch5. Printer Status Monitor and Control Panel
- Ch6. Maintenance
- Ch7. Troubleshooting
- Ch8. Specifications
- AppA. Glossary
- AppB. Index
8-6
Interface Connector and Cable
Chapter 8Specifications
Interface Connector and Cable
Be sure to use only a parallel interface cable that meets the specifica-
tions described below.
Note
Connectors:
Parallel 36-pin connector (printer)
EIA 25-pin connector (computer)
Cable type:
Shielded. Each signal and ground pair
should be twisted.
Pin assignments:
IEEE 1284 type-B connector
◆
Minolta does not warrant the use of any particular cable. The user
assumes all responsibility as to the quality and performance of the cable.