Printer User Manual
Table Of Contents
- CONTENTS
- Ch1. Introduction
- Ch2. Setting-Up
- Ch3. Using the Printer
- Ch4. Printer Driver
- Introduction
- System Requirements
- Installing the PagePro 1100 Printer Driver Under Windows 95/Windows 98/ Windows NT 4.0
- Installing the PagePro 1100 Printer Driver Under Windows 3.1
- Displaying the PagePro 1100 Printer Driver Setup Dialog
- Using the PagePro 1100 Printer Driver Setup Dialog
- Uninstalling the Printer Driver
- DOS Printing Utilities
- Ch5. Printer Status Monitor and Control Panel
- Ch6. Maintenance
- Ch7. Troubleshooting
- Ch8. Specifications
- AppA. Glossary
- AppB. Index
6-6
Replacing the Toner Cartridge
Chapter 6Maintenance
To Reset the Counter of the Toner Cartridge
Perform the following procedure to reset the toner cartridge counter
after you replace the toner cartridge.
1
While holding down the panel button, turn on the printer.
2
Keep the panel button held down, and the Ready indicator will
start to blink. After the Ready indicator has blinked for about 5
seconds, release the panel button. This should cause all the
indicators to start to blink.
3
After confirming that all the indicators are blinking, press and
hold down the panel button again for at least 5 seconds. During
this time, the Ready indicator only continues to blink and all the
other indicators turn off.
4
Release the panel button and only the Paper indicator starts to
blink.
5
After a few seconds, all the indicators start to blink again, indi-
cating that the toner cartridge counter has been reset.
6
Turn off the printer. The printer will be ready to print the next
time you turn it on.