Printer User Manual
Table Of Contents
- CONTENTS
- Ch1. Introduction
- Ch2. Setting-Up
- Ch3. Using the Printer
- Ch4. Printer Driver
- Introduction
- System Requirements
- Installing the PagePro 1100 Printer Driver Under Windows 95/Windows 98/ Windows NT 4.0
- Installing the PagePro 1100 Printer Driver Under Windows 3.1
- Displaying the PagePro 1100 Printer Driver Setup Dialog
- Using the PagePro 1100 Printer Driver Setup Dialog
- Uninstalling the Printer Driver
- DOS Printing Utilities
- Ch5. Printer Status Monitor and Control Panel
- Ch6. Maintenance
- Ch7. Troubleshooting
- Ch8. Specifications
- AppA. Glossary
- AppB. Index
5-7
Chapter 5Printer Status Monitor and Control Panel
Using the Control Panel
Paper
Paper Time Out
The printer automatically goes into a “paper time out” standby state
after about 10 minutes of inactivity in the Manual Feed mode, or when
a Paper Size Error occurs. Use this setting to specify what the printer
should do after it enters the paper time out state.
Proceed:
Selecting this option tells the printer to proceed with the job,
using paper from Tray1.
Clear:
Selecting this option tells the printer to cancel the current print
job.
None:
This option tells the printer to do nothing and stand by until
paper is fed manually or until it receives a command to cancel the cur-
rent print job.
Tray1 Setting
Multipurpose Tray
Selecting this option defines Tray1 as a multipurpose tray, which
means that Tray1 supports any paper size.