Electronics America Portable Projector User Manual

86
6. Maintenance
5. Connect the supplied power cable, turn on the Main Power switch and turn on the projector.
6. Finally, select the menu → [RESET] → [CLEAR LAMP HOURS] to reset the lamp usage hours.
NOTE:Whenyoucontinuetousetheprojectorforanother100hoursafterthelamphasreachedtheendofitslife,theprojector
cannot turn on and the menu is not displayed.
Ifthishappens,presstheHELPbuttonontheremotecontrolfor10secondstoresetthelampclockbacktozero.
Whenthelamptimeclockisresettozero,theLAMPindicatorgoesout.
M
ENU
STATUS
LAMP
AUTOADJ.SOURCE
FOCUS
M
ENU
STATUS
LAMP
AUTOADJ. SOURCE
FOCUS
M
ENU
STATUS
LAMP
AUTOADJ. SOURCE
FOCUS
M
ENU
STATUS
LAMP
AUTOADJ. SOURCE
FOCUS
4. Reattach the lamp cover.
(1)Slidethelampcoverbackuntilitsnapsintoplace.
(2)Tightenthescrewtosecurethelampcover.
 •Besuretotightenthescrew.
3. Install a new lamp housing.
(1)Insertanewlamphousinguntilthelamphousingispluggedintothesocket.
CAUTION
DonotusealampotherthantheNECreplacementlampNP07LP(NP610/NP510W/NP410W/NP610S/NP510WS)/
NP14LP(NP510/NP410/NP405/NP310/NP305).
OrderthisfromyourNECdealer.
(2) Push the top center of the lamp housing to secure it.
(3)Secureitinplacewiththetwoscrews.
 •Besuretotightenthescrews.