Operation Manual

79

Replacing the Lamp
Whenthelampreachestheendofitslife,theLAMPindicatorinthecabinetwillblinkred.Eventhoughthelamp
maystillbeworking,replacethelamptomaintaintheoptimalprojectorperformance.Afterreplacingthelamp,be
suretoclearthelamphourmeter.(
→
page76)
CAUTION
• DONOTTOUCHTHELAMPimmediatelyafterithasbeenused.Itwillbeextremelyhot.Turntheprojectoroff,
turnoffthemainpowerswitchandthendisconnectthepowercable.Allowatleastonehourforthelamptocool
beforehandling.
• DONOTREMOVEANYSCREWSexcepttwolamphousingscrews.Youcouldreceiveanelectricshock.
• Donotbreaktheglassonthelamphousing.
 Keepngerprintsofftheglasssurfaceonthelamphousing.Leavingngerprintsontheglasssurfacemight
causeanunwantedshadowandpoorpicturequality.
• Theprojectorwillturnoffandgointostandbymodewhenyoucontinuetousetheprojectorforanother100hours
afterthelamphasreachedtheendofitslife.Ifthishappens,besuretoreplacethelamp.Ifyoucontinuetousethe
lampafterthelampreachestheendofitslife,thelampbulbmayshatter,andpiecesofglassmaybescatteredin
thelampcase.Donottouchthemasthepiecesofglassmaycauseinjury.Ifthishappens,contactyourNECdealer
forlampreplacement.
To replace the lamp:
Optionallampandtoolsneededforreplacement:
• ReplacementlampNP06LP
• Phillipsscrewdriverorequivalent
1. Use a Philips screwdriver to push and release the tab.
Push and pull to remove the lamp cover.
6. Maintenance
1
2