Operation Manual

22
3. Projecting an Image (Basic Operation)
Note on Startup screen (Menu Language Select screen)
Whenyourstturnontheprojector,youwillgettheStartupmenu.Thismenugivesyoutheopportunitytoselect
oneofthe21menulanguages.
Toselectamenulanguage,followthesesteps:
1. Use the

,

,

or

button to select one of the 21
languages from the menu.
2. Press the ENTER button to execute the selection.
Afterthishasbeendone,youcanproceed tothe menu
operation.
Ifyouwant,youcanselectthemenulanguagelater.(
→
[LANGUAGE]onpage52, 65)
NOTE:
• Theprojectorcannotbeturnedofffor60secondsafterthelampisturnedonandwhilethePOWERindicatorisblinkinggreen.
• Ifyouturnontheprojectorimmediatelyafterthelampisturnedoff,thefansrunwithoutdisplayinganimageforsometime
and then the projector will display the image.
• Immediatelyafterturningontheprojector,screenickermayoccur.Thisisnormal.Wait3to5minutesuntilthelamplighting
is stabilized.
• Whenthe[ECOMODE]issetto[ON],theLAMPindicatorwilllightgreen.
• Ifoneofthefollowingthingshappens,theprojectorwillnotturnon.
- Iftheinternaltemperatureoftheprojectoristoohigh,theprojectordetectsabnormalhightemperature.Inthis
conditiontheprojectorwillnotturnontoprotecttheinternalsystem.Ifthishappens,waitfortheprojector’s
internalcomponentstocooldown.
- Whenthelampreachesitsendofusablelife,theprojectorwillnotturnon.Ifthishappens,replacethelamp.
(
→
page79)
- Ifthelampfailstolight,andiftheSTATUSindicatorashesonandoffinacycleofsixtimes,waitafullminute
andthenturnonthepower.
NOTE: Turning the Main Power Switch Off then Back On
Allow a minimum of one second between turning off the main power switch and turning it back on again.
Thesamewillbeappliedwhenapowerstripequippedwithaswitchandabreakerisused.
Failingtodosocouldresultinnopowertotheprojector.(Therewillbenostand-byLED)
Should this happen, unplug the power cable and plug it in again. Turn on the main power switch.