Operation Manual

20
2. Installation and Connections
Connecting the Supplied Power Cable
Connectthesuppliedpowercabletotheprojector.
Firstconnectthesuppliedpowercable’sthree-pinplugtotheACINoftheprojector,andthenconnecttheother
plugofthesuppliedpowercableinthewalloutlet.
NOTE:ToturnofftheACpowersupplywhentheprojectorispoweredon,usetheMainPowerSwitchorapowerstripequipped
with a switch and a breaker.
CAUTION:
Donottrytotouchtheventilationoutletontheleftfront(whenseenfromthefront)asitcanbecomeheated
whiletheprojectoristurnedonandimmediatelyaftertheprojectoristurnedoff.
CAUTION:
Donotunplugthepowercablefromthewalloutletorprojectorwhentheprojectorispoweredon.Doingsocan
causedamagetotheACINconnectoroftheprojectorand(or)theprongplugofthepowercable.
AboutDirectPowerOff
Theprojectorhasafeaturecalled“DirectPowerOff”.Thisfeatureallowstheprojectortobeturnedoff(evenwhen
projectinganimage)usingtheMainPowerSwitchordisconnectingtheACpowersupply.
NOTE: Before using Direct Power Off, be sure to allow at least 20 minutes immediately after turning on the projector and starting
to display an image.
Makesurethattheprongsarefullyinsertedintoboth
theACINandthewalloutlet.
Towalloutlet←