Operation Manual

13
COMPUTER1IN
COMPUTER2IN
PHONE
2. Installation and Connections

Making Connections
Connecting Your PC or Macintosh Computer
NOTE: When using with a notebook PC, be sure to connect the projector and notebook PC while the projector is in standby mode
and before turning on the power to the notebook PC.
In most cases the output signal from the notebook PC is not turned on unless connected to the projector before being powered up.
* If the screen goes blank while using your remote control, it may be the result of the computer’s screen-saver or power manage-
ment software.
Enablingthecomputer’sexternaldisplay
DisplayinganimageonthenotebookPC’sscreendoesnotnecessarilymeanitoutputsasignaltotheprojector.
WhenusingaPCcompatiblelaptop,acombinationoffunctionkeyswillenable/disabletheexternaldisplay.
Usually,thecombinationofthe“Fn”keyalongwithoneofthe12functionkeysgetstheexternaldisplaytocomeon
oroff.Forexample,NEClaptopsuseFn+F3,whileDelllaptopsuseFn+F8keycombinationstotogglethrough
externaldisplayselections.
IBMVGAorCompatibles(Notebook
type)orMacintosh(Notebooktype)
NOTE: For older Macintosh, use a commercially
available pin adapter (not supplied) to connect to
your Mac’s video port.
• Firstturnoffthecomputerandtheprojectorbeforemakingconnections.
• Turndownthevolumeonthecomputerbeforeconnectinganaudiocabletotheheadphonejackofthecom-
puter.Afterconnectingthecomputertotheprojector,youcanadjustthesoundlevelonthecomputerandthe
projectortoyourpreference.
• Youarerecommendedtoconnectanaudiocabletoanaudiooutconnector(minijacktype)ifany.
NOTE: The NP3200/NP2200/NP1200 is not compatible with video decoded outputs of either the NEC ISS-6020 and ISS-6010
switchers.
NOTE: An image may not be displayed correctly when a Video or S-Video source is played back via a commercially available scan converter.
This is because the projector will process a video signal as a computer signal at the default setting. In that case, do the following.
* When an image is displayed with the lower and upper black portion of the screen or a dark image is not displayed correctly:
Project an image to fill the screen and then press the AUTO ADJ button on the remote control or the AUTO ADJUST button on
the projector cabinet.
Stereomini-plugaudiocable(notsupplied)
VGAsignalcable(supplied)
TominiD-Sub15-pinconnectorontheprojector.
Itisrecommendedthatyouuseacommercially
availabledistributionamplierifconnectinga
signalcablelongerthantheonesupplied.
Stereo
mini-plug
audio
cable (not
supplied)
BNC×5cable(notsupplied)
NOTE: Both COMPUTER 1 IN and
COMPUTER 3 (DVI-D) IN connectors
support Plug & Play (DDC2B).