Operation Manual

10
1. Introduction
Battery Installation
NOTE: Actual operating range may differ slightly from that shown in the drawing.
TIP: You can determine which remote sensor on the projector is enabled in wireless mode. The options are: [FRONT/BACK],
[FRONT], or [BACK]. (
→
page 68)
• Theinfraredsignaloperatesbyline-of-sightuptoadistanceofabout22feet/7mandwithina60-degreeangle
oftheremotesensorontheprojectorcabinet.
• Theprojectorwillnotrespondifthereareobjectsbetweentheremotecontrolandthesensor,orifstronglight
fallsonthesensor.
 Weakbatterieswillalsopreventtheremotecontrolfromproperlyoperatingtheprojector.
Operating Range for Wireless Remote Control
30°
30°
30°
30°
30°
30°
30°
30°
Remotesensoronprojectorcabinet
Remotecontrol
Remotecontrol
7m/22feet 7m/22feet
7m/22feet
7m/22feet
OPEN
1
Pressrmlyandslidethebattery
coveroff.
2
Installnewbatteries(AAA).En-
surethatyouhavethebatteries’
polarity(+/−)alignedcorrectly.
OPEN
3
Slipthecoverbackoverthebat-
teriesuntilitsnapsintoplace.Do
notmixdifferenttypesofbatter-
iesornewandoldbatteries.