Operation Manual

8
1. Introduction
Terminal Panel Features
1. COMPUTER1IN/ComponentConnector(MiniD-
Sub15Pin)(
→
page13,16,17)
 AUDIOIN(StereoMiniJack)(
→
page13,16,17)
2. COMPUTER2IN/Component(R/Cr,G/Y,B/Cb,H,
V)Connectors(BNC×5)(
→
page13,18)
 AUDIOIN(StereoMiniJack)(
→
page13)
3. COMPUTER 3 (DVI-D) IN Connector (24 Pin)
(HDCPcompatible)(
→
page15)
 AUDIOIN(StereoMiniJack)(
→
page15)
4. S-VIDEOINConnector(MiniDIN4Pin)(
→
page
18)
5. VIDEOINConnector(RCA)(
→
page18)
6. VIDEO/S-VIDEOAUDIOL/MONO,R(RCA)(
→
page18)
7. MONITOR OUT Connector (Mini D-Sub 15 Pin)
(
→
page16)
8. AUDIOOUT(StereoMiniJack)(
→
page16)
9. PCCONTROLPort(D-Sub9Pin)(
→
page96,97)
UsethisporttoconnectyourPCorcontrolsystem
to controlyour projectorvia a serialcable.This
enables youtocontrol the projector using serial
communicationprotocol. A commercially available
RS232Ccrosscableisrequiredtousethisport.You
canalsocontrol the projector byusingPCControl
UtilityPro4containedonthesuppliedNECProjec-
torCD-ROM.TodosoyoumustrsthavePCCon-
trolUtilityPro4installedonyourPC(
→
page48).If
youarewritingyourownprogram,typicalPCcontrol
codesareonpage96.
10.LANPort(RJ-45)(
→
page19)
Theactualappearanceoftheterminalpanelmaydifferslightlyfromthatshowninthedrawing,butthisdoesnotaf-
fecttheprojector’sperformance.
679
10 2
154 8
3