Electronics America Portable Projector User's Manual
Table Of Contents
- INDEX
- Front cover
- Important Information
- 1. Introduction
- 2. Installation and Connections
- 3. Projecting an Image (Basic Operation)
- 4. Convenient Features
- (1) Turning off the Image and Sound
- (2) Freezing a Picture
- (3) Enlarging a Picture
- (4) Changing Eco Mode
- (5) Checking Energy-Saving Effect [CARBON METER]
- (6) Preventing the Unauthorized Use of the Projector [SECURITY]
- (7) Using the Optional Remote Mouse Receiver (NP01MR)
- (8) Network Setting by Using an HTTP Browser (NP215 only)
- 5. Using On-Screen Menu
- 6. Maintenance
- 7. Appendix
4
1. Introduction
Part Names of the Projector
Zoom Lever
(→ page 22)
Controls
(→ page 5)
Lens
Lens Cap
Built-in Security Slot ( )*
Adjustable Tilt Foot Lever
(→ page 21)
Adjustable Tilt Foot
(→ page 21)
Remote Sensor
(→ page 7)
Front/Top
AC Input
Connect the supplied power
cable's three-pin plug here, and
plug the other end into an active
wall outlet. (→ page 16)
Terminal Panel
(→ page 5)
Rear
* This security slot supports the MicroSaver ® Security System.
Ventilation (outlet)
Heated air is ex-
hausted from here.
Ventilation (inlet)
Lamp Cover
(→ page 66)
Focus Ring
(→ page 22)
Ventilation (inlet)
Monaural Speaker (7W)
Rear Foot
(→ page 21)
Security chain opening
Attach an anti-theft device.
The security chain opening accepts
security wires or chains up to 0.18
inch/4.6 mm in diameter.
Spacer (black rubber)
To fine-adjust the height of the rear
foot, remove the spacer and rotate
the rear foot to the desired height.