Operation Manual

116
9. Appendix
Over-TemperatureProtection
Iftheprojectorinsidetemperaturegetstoohigh,thelightmoduleswillbe turnedoffautomaticallyandthestatus
indicatorwillstarttoblink(2-cycleOnandOFF).
Shouldthishappen,dothefollowing:
• Unplugthepowercordafterthecoolingfansstop.
• Movetheprojectortoacoolerlocationiftheroomwhereyouarepresentingisparticularlytoowarm.
• Cleantheventsiftheyarecloggedwithdust.
• Waitabout60minutesuntiltheinsideoftheprojectorbecomescoolenough.