Operation Manual

2. Projecting an Image (Basic Operation)

❿ After Use

Preparation:Makesurethattheprojectoristurnedoff.

1. Unplugthepowercord.

2. Disconnect any other cables.

• RemovetheUSBmemoryifitisinsertedintotheprojector.

3. Retractadjustabletiltfootifextended.

(M402W/M362W/M322W/M402X/M362X/M322X/M282X/M402H/M322Honly)

4.Slidethelenscovertothelefttocoverthelens.

5. Puttheprojectorandaccessoriesinthesuppliedsoftcase.

Place the projector in the soft case with the lens facing upward as shown below. This is to prevent the lens from

damage.

Inserttheprojectorwiththelens

facing upward

NOTE:Whenplacingtheprojectorinthesoftcase,retractthetiltfootandtherearfeet.Failuretodosomaycasedamagetothe

projector.

(M352WS/M302WS/M322XSonly)

4. Reattach the lens cap

① Put the lens cap on the top of the lens.

② Push to cover the lens completely.

CAUTION:

Usecautionwhenputtingtheprojectorinthesoftcaseimmediatelyaftertheprojectorhasbeenoperating.The

projectorcabinetishot.