User's Manual
33
5. Performing Stacking/Tiling Correction
10. Drag the various points onto the region
set up in the pre
vious step
Match the 4 points displayed in the second projector
to
the 4 points of the rst projector specied earlier.
Pre
ss the ENTER key at the end of the operation.
The following operations can be carried out using
the va
rious keys of the keyboard.
ENTER key Proceed to the next step.
Backspace key
Return to the previous step.
ESC key Suspend the operation.
↑↓←→ keys Move the selected point.
The point will move faster when the
shift key is held down during the
operation.
p key Change the selected points in a
clockwise dire
ction.
n key Change the selected points in an
anticlockwise dire
ction.
T
he following message will be projected in this step.
Center each point on its corresponding point in
the other projector.
Ente
r Key - Next Step.
Back
space Key - Previous Step
Es
c Key - Quit
Note
When specifying the region of the 4 points and
proceeding to the next step by pressing the
ENTER key, the 4 points specied in the previous
step may not display properly sometimes. In
this case, check the LAN cable connection, and
carry out the [Calibrate] operation again after
suspending opera
tion by pressing the ESC key.
When performing stacking correction
When performing tiling correction