User's Manual

Note

• The [CORNERSTONE] screen will not be displayed when making adjustments with the [KEYSTONE] screen, or when

setting [GEOMETRIC CORRECTION]. To perform the [CORNERSTONE] adjustment, hold down the 3D REFORM

button for 2 seconds or longer, and clear the [KEYSTONE] adjustment values.

Likewise, the [KEYSTONE] screen will not be displayed when making adjustments with the [CORNERSTONE]

screen, or when setting [GEOMETRIC CORRECTION]. To perform the [KEYSTONE] adjustment, hold down the 3D

REFORM button for 2 seconds or longer, and clear the [CORNERSTONE] adjustment values.

• When the projector's on-screen menu is used while projecting in multi screen with tiling correction, the edge

blending function is canceled while the on-screen menu is displayed, resulting in bands of different brightnesses

at the overlapping parts of the projected images. (The image returns to as it was before when the on-screen menu

turns off.)

- Similarly, when the input signal is switched and the signal name is displayed, the edge blending function is

canceled. We recommend using the projector's on-screen menu to set SETUP

→

SOURCE DISPLAY

to [OFF] beforehand.

• The edge blending function is optimized for when the presetting is set to "Graphic".

If the presetting differs depending on the input signal, differences in brightness may occur at the parts where the

projected images overlap.

• When using the tiling function with the NP-PA500U/NP-PX750U/NP-PH1000U/NP-PH1400U, pay attention to the

following:

- Only signals with a vertical frequency of 48Hz to 60Hz are supported.

When signals other than the above are input, they are projected with the edge blending function canceled.

(Bands of different brightnesses appear at the overlapping parts of the projected images.)

- The PIP/PBP function and the remote control's sectional zoom function cannot be used.

• When using the NP-PX750 series, unify the color wheel types (6 Segment-White / 6 Segment-Color) included with

the main unit.

• Stacking/tiling correction is performed based on the test patterns, so [LENS MEMORY] cannot be used.

• This cannot be used simultaneously with the edge blending function on the projector's on-screen menu.

Turn off the setting on the on-screen menu before performing stacking/tiling correction.

• Stacking/tiling correction will not be applied on video projected by the STEREO DVI terminal of NP-PH1400U.

Reference

• Settinga[PROJECTORNAME]toaprojectorinadvancewillaidinrecognitioneveninthelistdisplayedintheMulti

ScreenTool[CommunicationSettings],andwillbeconvenientatthetimeofinstallation.

 Pleaseseetheprojectoruser'smanualforinformationaboutthe[PROJECTORNAME]setting.

4. Preparation of the Projectors