Electronics America Network Cables User Manual

CHAPTER 7 PCI CONTROLLER
400
Preliminary User’s Manual S15543EJ1V0UM
7.5.16 P_PPCR (PCI Power Control Register)
This register is used to control the power state for PPMI.
See 7.6 Information for Software for further details.
R/WBits Field
Internal
bus
PCI
Default Description
31 PMRDY R/W R 0 Power Management Ready.
‘1’ indicates that the transition of power state has been done.
When PCI-Host writes to PowerState field of PMCSR register in
Configuration Space, this bit is reset to ‘0’. the V
R
4120A should
be set ‘1’ to this bit after the transition of power state has been
done.
30 PMERQ W - 0 PME# issue.
This bit is only writeable from Internal bus-side.
The PCI Controller asserts PME# signal when ‘1’ is written to this
bit.
If PCI-Host want to clear PME# asserting, it should write ‘1’ to
PME_Status bit in PMCSR register, or disable PME_En bit in
PMCSR register. See
7.6
for further details.
29:4 Reserved - - 0 Hardwired to ‘0’s.
3 PMRQ0 R/W R 0 The transition to D0 power state issued.
‘1’ indicates that PCI-Host issues the transition to D0 state.
The V
R
4120A should write ‘1’ to this bit in order to clear after the
recognition that this bit is set.
2 PMRQ1 R/W R 0 The transition to D1 power state issued.
‘1’ indicates that PCI-Host issues the transition to D1 state.
The V
R
4120A should write ‘1’ to this bit in order to clear after the
recognition that this bit is set.
1 Reserved - - 0 Hardwired to a ‘0’.
0 PMRQ3 R/W R 0 The transition to D3 power state issued.
‘1’ indicates that PCI-Host issues the transition to D3 state.
The V
R
4120A should write ‘1’ to this bit in order to clear after the
recognition that this bit is set.
7.5.17 P_SWRR (Software Reset Register)
This register is used for Software Reset and can be written only from PCI-side. Writing any value to this register
causes the Software Reset. When this register is written, the SRREQ bit in P_IGSR register will be set and an internal
interrupt will be asserted to the V
R
4120A. The V
R
4120A is responsible to execute reset-operations (for example,
asserting warm-reset to all blocks).
R/WBits Field
Internal
bus
PCI
Default Description
31:0 SWRS - W - This register is write-only.