NC800C DLP Cinema Projector User's Manual

43
6. Appendix
6-6. Specifications
Model No.
Projection method
Panel resolution
Lamp type
Screen sizes
Contrast ratio
Lens adjustment function
Signal input terminal
External Control
Power supply voltage
Input current
Power consumption
Cooling method
Noise level
Installation
Dimensions
Net weight
Environment
Regulations
NC800C
3 chip DMD reflector method (DLP
®
method)
2048 x 1080
1.25 kW xenon lamp
8 m (Width) (Depends on setup conditions)
200:1 or above
Motorized lens shift (vertical/horizontal), motorized zoom, motorized focus, douser
RGB DIGITAL (2) DVI-D 24pin（TMDS specification）
SDI (2) BNC （SMPTE 292M）
RS232C (1) D-sub 9 pin
Remote control
LAN port (RJ-45) x 2
USB port (type A)
GPIO port (D-sub 37 pin)
PC card slot (1) PCMCIA type II, card bus
LAN port for the Touch Panel (Note)
AC100 to 120V 50/60Hz,
AC200 to 240V 50/60Hz
12A (100 - 120V), 8.5A (200 - 240V)
1.2kW to 1.44kW (100 - 120V), 1.7kW (200 - 240V)
Cooling air system (includes dust filter)
Less than 45dB (When set to minimum brightness mode)
Orientation: Desktop/front, Desktop/rear, Ceiling/front, Ceiling/rear
670mm(W) x 826mm(D) x 423mm(H) (Does not include protruding portions Includes foot)
66 kg (Excluding lens)
Operating temperature: 5 to 35˚C
Operating humidity: 10 to 85% (non-condensing)
Storage temperature: -10 to 50˚C
Storage humidity: 10 to 85% (non-condensing)
<Safety> <EMC>
USA UL60950-1 FCC Class A
Canada CSA60950-1 ICES-003 Class A
Europe EN60950-1 EN55022 Class A
EN55024
Oceania IEC60950-1
AS/NZS CISPR. 22 Class A
Japan J60950 VCCI Class A
Asia IEC60950-1 CISPR. 22
(Note) This is the terminal for future expansions.
* Note that these specifications and design can change without prior notice.