Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 97
System Access configuration
The following table describes the System Access Configuration commands.
Table 93 System Access Configuration commands
Command
Description
[no] access http enable
Enables or disables HTTP (Web) access to the Browser-based
Interface. It is enabled by default.
Command mode: Global configuration
access http port <http port
number>
Sets the switch port used for serving switch Web content. The default
is HTTP port 80.
Command mode: Global configuration
[no] access snmp {read-
only|read-write}
Disables or provides read-only/write-read SNMP access.
Command mode: Global configuration
[no] access tsbbi enable
Enables or disables BBI configuration controls for Telnet and SSH. It is
disabled by default.
Command mode: Global configuration
[no] access telnet enable
Enables or disables telnet server. It is enabled by default.
Command mode: Global configuration
access telnet port <Telnet
port number>
Sets an optional telnet server port number for cases where the server
listens for telnet sessions on a non-standard port. The default is 23.
Command mode: Global configuration
access tftp-port <TFTP port
number>
Sets an optional telnet server port number for cases where the server
listens for TFTP sessions on a non-standard port. The default is 69.
Command mode: Global configuration
show access
Displays the current system access parameters.
Command mode: All except User EXEC
Management Networks configuration
The following table describes the Management Networks Configuration commands. You can configure
up to 10 management networks on the switch.
Table 94 Management Networks Configuration commands
Command
Description
access management-network <IP
address> <IP mask>
Adds a defined network through which switch access is
allowed through Telnet, SNMP, RIP, or the browser-based
interface. A range of IP addresses is produced when used with
a network mask address. Specify an IP address and mask
address in dotted-decimal notation.
Command mode: Global configuration
no access management-network <IP
address> <IP mask>
Removes a defined network, which consists of a management
network address and a management network mask address.
Command mode: Global configuration
show access management-network
Displays the current management networks parameters.
Command mode: All except User EXEC
clear access management-network
Clears the management network definitions.
Command mode: All except User EXEC