Command Reference Guide

Error! Use the Home tab to apply 見出し 1 to the text that you want to appear here. 129
IGMPv3 Snooping configuration
The following table describes the IGMP version 3 Snooping Configuration commands.
Table 141 IGMPv3 Snooping commands
Command
Description
ip igmp snoop igmpv3 sources
{<1-64>}
Configures the maximum number of IGMP multicast sources to snoop
from within the group record. The default is 8.
Command mode: Global configuration
[no] ip igmp snoop igmpv3 v1v2
Enables or disables snooping on IGMP version 1 and version 2 reports.
The default value is enabled.
Command mode: Global configuration
[no] ip igmp snoop igmpv3
exclude
Enables or disables snooping on IGMPv3 Exclude Reports. The default
value is enabled.
Command mode: Global configuration
ip igmp snoop igmpv3 enable
Enables IGMP version 3.
Command mode: Global configuration
no ip igmp snoop igmpv3 enable
Disables IGMP version 3. The default value is disabled.
Command mode: Global configuration
show ip igmp
Displays the current IGMP configuration.
Command mode: All
IGMP static multicast router configuration
The following table describes the Static Multicast Router Configuration commands.
NOTE: When you configure a static multicast router on a VLAN, the process of learning multicast
routers is disabled for that VLAN.
Table 142 IGMP Static Multicast Router commands
Command
Description
ip igmp mrouter <port number>
<1-4094> <1-3>
Selects a port/VLAN combination on which the static multicast
router is connected, and configures the IGMP version (1 or 2)
of the multicast router.
Command mode: Global configuration
no ip igmp mrouter <port number>
<1-4094> <1-3>
Removes a static multicast router from the selected port/VLAN
combination.
Command mode: Global configuration
ip igmp mrouter portchannel
{<trunk number (1-12)>|<LACP
trunk (13-40>} <1-4094> <1-3>
Selects a trunk group/VLAN combination on which the static
multicast router is connected, and configures the IGMP
version (1, 2, or 3) of the multicast router.
Command mode: Global configuration
show ip igmp mrouter
Displays the current IGMP Static Multicast Router parameters.
Command mode: All
IGMP filtering configuration
The following table describes the IGMP Filter Configuration commands.
Table 143 IGMP Filtering commands
Command
Description
ip igmp filtering
Enables IGMP filtering globally.
Command mode: Global configuration
no ip igmp filtering
Disables IGMP Filtering globally. This is the default.
Command mode: Global configuration
show ip igmp filtering
Displays the current IGMP Filtering parameters.
Command mode: All