Electronics America Switch Reference Guide
Table Of Contents
- SmartPanel
- Browser-based interface
- Command Line Interface
- Introduction
- Information Menu
- Introduction
- Menu overview
- System Information Menu
- SNMPv3 Information Menu
- System information
- Show last 100 syslog messages
- System user information
- Layer 2 information
- FDB information menu
- Trunk group information
- Layer 3 information
- ARP information
- IP information
- IGMP multicast group information
- IGMP multicast router port information
- Link status information
- Port information
- Group information
- Information dump
- Statistics Menu
- Configuration Menu
- Introduction
- System configuration
- System host log configuration
- Secure Shell Server configuration
- RADIUS server configuration
- TACACS+ server configuration
- NTP server configuration
- System SNMP configuration
- SNMPv3 configuration
- SNMPv3 User Security Model configuration
- SNMPv3 View configuration
- SNMPv3 View-based Access Control Model configuration
- SNMPv3 Group configuration
- SNMPv3 Community Table configuration
- SNMPv3 Target Address Table configuration
- SNMPv3 Target Parameters Table configuration
- SNMPv3 Notify Table configuration
- System Access configuration
- Port configuration
- Spare Ports Group configuration
- Group configuration
- Configuration Dump
- Saving the active switch configuration
- Restoring the active switch configuration
- Operations Menu
- Boot Options Menu
- Maintenance Menu
Command Line Interface 78
Port configuration
Command: /cfg/port <port number>
[Port 1 Menu]
speed - Set link speed and force full duplex mode
fctl - Set flow control
auto - Set auto negotiation
name - Set port name
ena - Enable port
dis - Disable port
cur - Display current port configuration
This menu enables you to configure settings for individual switch ports. This command is enabled by default.
NOTE: Port 19 is a port for switch management interface (interface 256). Cross-link ports (17-18) are not
available on the SmartPanel software.
The following table describes the Port Configuration Menu options.
Table 80 Port Configuration Menu options
Command Description
speed 10|100|1000|any Sets the link speed. Not all options are valid on all ports. The choices
include:
• 10 Mb/s
• 100 Mb/s
• 1000 Mb/s
• “any,” for automatic detection (default)
Note: Ports 1-16 are set to 1000 Mb/s, and cannot be changed.
fctl rx|tx|both|none Sets the flow control. The choices include:
• Receive (rx) flow control
• Transmit (tx) flow control
• Both receive and transmit flow control (default)
• No flow control
auto on|off Enables or disables auto-negotiation for the port. The default is
enabled.
name <1-64 characters>|none Set the port name.
ena Enables the port.
dis Disables the port. To temporarily disable a port without changing its
configuration attributes, see the “Operation Menu” section.
cur Displays current port parameters.
Spare Ports Group configuration
Command: /cfg/spgroup
[Spare Ports Group Menu]
addport - Add ports to the group
cur - Display current group configuration
Use these menu options to set unused ports to Spare Ports Group. Set the ports, which Port Group 1-5 do not
contain, to Spare Ports Group.
The following table describes the Spare Ports Group Configuration menu options.
Table 81 Spare Ports Group Configuration menu options
Command Description
add <port number> Adds the specified port to Spare Ports Group.
cur Displays the current Spare Ports Group configuration.