Electronics America Switch Reference Guide
Table Of Contents
- SmartPanel
- Browser-based interface
- Command Line Interface
- Introduction
- Information Menu
- Introduction
- Menu overview
- System Information Menu
- SNMPv3 Information Menu
- System information
- Show last 100 syslog messages
- System user information
- Layer 2 information
- FDB information menu
- Trunk group information
- Layer 3 information
- ARP information
- IP information
- IGMP multicast group information
- IGMP multicast router port information
- Link status information
- Port information
- Group information
- Information dump
- Statistics Menu
- Configuration Menu
- Introduction
- System configuration
- System host log configuration
- Secure Shell Server configuration
- RADIUS server configuration
- TACACS+ server configuration
- NTP server configuration
- System SNMP configuration
- SNMPv3 configuration
- SNMPv3 User Security Model configuration
- SNMPv3 View configuration
- SNMPv3 View-based Access Control Model configuration
- SNMPv3 Group configuration
- SNMPv3 Community Table configuration
- SNMPv3 Target Address Table configuration
- SNMPv3 Target Parameters Table configuration
- SNMPv3 Notify Table configuration
- System Access configuration
- Port configuration
- Spare Ports Group configuration
- Group configuration
- Configuration Dump
- Saving the active switch configuration
- Restoring the active switch configuration
- Operations Menu
- Boot Options Menu
- Maintenance Menu
Command Line Interface 76
User Access Control configuration
Command: /cfg/sys/access/user
[User Access Control Menu]
uid - User ID Menu
eject - Eject user
usrpw - Set user password (user)
opw - Set operator password (oper)
admpw - Set administrator password (admin)
cur - Display current user status
The following table describes the User Access Control menu options.
Table 76 User Access Control Configuration menu options
Command Description
uid <1-10> Displays the User ID Menu for the selected user.
eject <user-name> Ejects the selected user from the switch.
usrpw <1-128
characters>
Sets the user (user) password (maximum 128 characters). The user has no direct
responsibility for switch management. He or she can view switch status information
and statistics, but cannot make any configuration changes.
opw <1-128 characters> Sets the operator (oper) password (maximum 128 characters). The operator
manages all functions of the switch. He or she can view all switch information and
statistics and can reset ports or the entire switch.
admpw <1-128
characters>
Sets the administrator (admin) password (maximum 128 characters). The super
user administrator has complete access to all menus, information, and
configuration commands on the switch, including the ability to change both the user
and administrator passwords.
cur Displays the current user status.
User ID configuration
Command: /cfg/sys/access/user/uid <uid number>
[User ID 1 Menu]
cos - Set class of service
name - Set user name
pswd - Set user password
ena - Enable user ID
dis - Disable user ID
del - Delete user ID
cur - Display current user configuration
The following table describes the User ID Configuration menu options.
Table 77 User ID Configuration menu options
Command Description
cos
<user|oper|admin>
Sets the Class-of-Service to define the user’s authority level.
name <1-8
characters>
Defines the user name.
pswd <1-128
characters>
Sets the user password of up to 128 characters maximum.
ena Enables the user ID.
dis Disables the user ID.
del Deletes the user ID.
cur Displays the current user ID parameters.