Electronics America Switch Reference Guide
Table Of Contents
- SmartPanel
- Browser-based interface
- Command Line Interface
- Introduction
- Information Menu
- Introduction
- Menu overview
- System Information Menu
- SNMPv3 Information Menu
- System information
- Show last 100 syslog messages
- System user information
- Layer 2 information
- FDB information menu
- Trunk group information
- Layer 3 information
- ARP information
- IP information
- IGMP multicast group information
- IGMP multicast router port information
- Link status information
- Port information
- Group information
- Information dump
- Statistics Menu
- Configuration Menu
- Introduction
- System configuration
- System host log configuration
- Secure Shell Server configuration
- RADIUS server configuration
- TACACS+ server configuration
- NTP server configuration
- System SNMP configuration
- SNMPv3 configuration
- SNMPv3 User Security Model configuration
- SNMPv3 View configuration
- SNMPv3 View-based Access Control Model configuration
- SNMPv3 Group configuration
- SNMPv3 Community Table configuration
- SNMPv3 Target Address Table configuration
- SNMPv3 Target Parameters Table configuration
- SNMPv3 Notify Table configuration
- System Access configuration
- Port configuration
- Spare Ports Group configuration
- Group configuration
- Configuration Dump
- Saving the active switch configuration
- Restoring the active switch configuration
- Operations Menu
- Boot Options Menu
- Maintenance Menu
Command Line Interface 71
Table 67 SNMPv3 View Configuration Menu options
Command Description
del Deletes the vacmViewTreeFamily group entry.
cur Displays the current vacmViewTreeFamily configuration.
SNMPv3 View-based Access Control Model configuration
Command: /cfg/sys/ssnmp/snmpv3/access <access number>
[SNMPv3 vacmAccess 1 Menu]
name - Set group name
model - Set security model
level - Set minimum level of security
rview - Set read view index
wview - Set write view index
nview - Set notify view index
del - Delete vacmAccess entry
cur - Display current vacmAccess configuration
The view-based Access Control Model defines a set of services that an application can use for checking access
rights of the user. Access control is needed when the user has to process SNMP retrieval or modification request
from an SNMP entity.
The following table describes the User Access Control Configuration Menu options.
Table 68 View-based Access Control Configuration Menu options
Command Description
name <1-32
characters>
Defines the name of the group, up to a maximum of 32 characters.
model
usm|snmpv1|snmpv2
Selects the security model to be used.
level
noAuthNoPriv|authN
oPriv|authPriv
Defines the minimum level of security required to gain access rights. The level
noAuthNoPriv means that the SNMP message will be sent without authentication and
without using a privacy protocol. The level
authNoPriv means that the SNMP message
will be sent with authentication but without using a privacy protocol. The
authPriv
means that the SNMP message will be sent both with authentication and using a privacy
protocol.
rview <1-32
characters>
Defines a 32 character long read view name that allows you read access to a particular
MIB view. If the value is empty or if there is no active MIB view having this value then no
access is granted.
wview <1-32
characters>
Defines a 32 character long write view name that allows you write access to the MIB view.
If the value is empty or if there is no active MIB view having this value then no access is
granted.
nview <1-32
characters>
Defines a 32 character long notify view name that allows you notify access to the MIB
view.
del Deletes the View-based Access Control entry.
cur Displays the View-based Access Control configuration.