Electronics America Switch Reference Guide
Table Of Contents
- SmartPanel
- Browser-based interface
- Command Line Interface
- Introduction
- Information Menu
- Introduction
- Menu overview
- System Information Menu
- SNMPv3 Information Menu
- System information
- Show last 100 syslog messages
- System user information
- Layer 2 information
- FDB information menu
- Trunk group information
- Layer 3 information
- ARP information
- IP information
- IGMP multicast group information
- IGMP multicast router port information
- Link status information
- Port information
- Group information
- Information dump
- Statistics Menu
- Configuration Menu
- Introduction
- System configuration
- System host log configuration
- Secure Shell Server configuration
- RADIUS server configuration
- TACACS+ server configuration
- NTP server configuration
- System SNMP configuration
- SNMPv3 configuration
- SNMPv3 User Security Model configuration
- SNMPv3 View configuration
- SNMPv3 View-based Access Control Model configuration
- SNMPv3 Group configuration
- SNMPv3 Community Table configuration
- SNMPv3 Target Address Table configuration
- SNMPv3 Target Parameters Table configuration
- SNMPv3 Notify Table configuration
- System Access configuration
- Port configuration
- Spare Ports Group configuration
- Group configuration
- Configuration Dump
- Saving the active switch configuration
- Restoring the active switch configuration
- Operations Menu
- Boot Options Menu
- Maintenance Menu
Command Line Interface 60
Configuration Menu
Introduction
The Configuration Menu is only available from an administrator login. It includes submenus for configuring every
aspect of the switch. Changes to configuration are not active until explicitly applied. Changes can be saved to non-
volatile memory (NVRAM).
Menu information
Command: /cfg
[Configuration Menu]
sys - System-wide Parameter Menu
port - Port Menu
spgroup - Spare Ports Group Menu
group - Group Menu
dump - Dump current configuration to script file
ptcfg - Backup current configuration to FTP/TFTP server
gtcfg - Restore current configuration from FTP/TFTP server
The following table describes the Configuration Menu options.
Table 57 Configuration Menu options
Command Usage
sys Displays the System Menu.
port <port number> Displays the Port Menu.
spgroup Displays the Spare Ports Group Menu.
group <group number> Displays the Group Menu.
dump Dumps current configuration to a script file.
ptcfg <server IP address> <filename on
host>
Backs up current configuration to TFTP or FTP server.
gtcfg <server IP address> <filename on
host>
Restores current configuration from TFTP or FTP server.
Viewing, applying, reverting, and saving changes
As you use the configuration menus to set switch parameters, the changes you make do not take effect
immediately. All changes are considered pending until you explicitly apply them. Also, any changes are lost the
next time the switch boots unless the changes are explicitly saved.
While configuration changes are in the pending state, you can:
• View the pending changes
• Apply the pending changes
• Revert to restore configuration parameters set with the last apply command
• Save the changes to flash memory