Electronics America Switch Reference Guide
Table Of Contents
- SmartPanel
- Browser-based interface
- Command Line Interface
- Introduction
- Information Menu
- Introduction
- Menu overview
- System Information Menu
- SNMPv3 Information Menu
- System information
- Show last 100 syslog messages
- System user information
- Layer 2 information
- FDB information menu
- Trunk group information
- Layer 3 information
- ARP information
- IP information
- IGMP multicast group information
- IGMP multicast router port information
- Link status information
- Port information
- Group information
- Information dump
- Statistics Menu
- Configuration Menu
- Introduction
- System configuration
- System host log configuration
- Secure Shell Server configuration
- RADIUS server configuration
- TACACS+ server configuration
- NTP server configuration
- System SNMP configuration
- SNMPv3 configuration
- SNMPv3 User Security Model configuration
- SNMPv3 View configuration
- SNMPv3 View-based Access Control Model configuration
- SNMPv3 Group configuration
- SNMPv3 Community Table configuration
- SNMPv3 Target Address Table configuration
- SNMPv3 Target Parameters Table configuration
- SNMPv3 Notify Table configuration
- System Access configuration
- Port configuration
- Spare Ports Group configuration
- Group configuration
- Configuration Dump
- Saving the active switch configuration
- Restoring the active switch configuration
- Operations Menu
- Boot Options Menu
- Maintenance Menu
Command Line Interface 58
TCP statistics
Command: /stats/mp/tcb
All TCP allocated control blocks:
10ad41e8: 0.0.0.0 0 <=> 0.0.0.0 80 listen
10ad5790: 47.81.27.5 1171 <=> 47.80.23.243 23 established
The following table describes the Transmission Control Protocol (TCP) control block (TCB) statistics shown in this
example:
Table 53 MP specified TCP statistics
Description Example statistic
Memory 10ad41e8/10ad5790
Destination IP address 0.0.0.0/47.81.27.5
Destination port 0/1171
Source IP 0.0.0.0/47.80.23.243
Source port 80/23
State listen/established
UDP statistics
Command: /stats/mp/ucb
All UDP allocated control blocks:
161: listen
The following table describes the User Datagram Protocol (UDP) control block (UCB) statistics shown in this
example:
Table 54 UDP statistics
Description Example Statistic
Control block 161
State listen
CPU statistics
Command: /stats/mp/cpu
CPU utilization:
cpuUtil1Second: 8%
cpuUtil4Seconds: 9%
cpuUtil64Seconds: 8%
The following table describes the management port CPU utilization statistics:
Table 55 CPU statistics
Statistics Description
cpuUtil1Second The utilization of MP CPU over 1 second. This is shown as a percentage.
cpuUtil4Seconds The utilization of MP CPU over 4 seconds. This is shown as a percentage.
cpuUtil64Seconds The utilization of MP CPU over 64 seconds. This is shown as a percentage.