Electronics America Switch Reference Guide
Table Of Contents
- SmartPanel
- Browser-based interface
- Command Line Interface
- Introduction
- Information Menu
- Introduction
- Menu overview
- System Information Menu
- SNMPv3 Information Menu
- System information
- Show last 100 syslog messages
- System user information
- Layer 2 information
- FDB information menu
- Trunk group information
- Layer 3 information
- ARP information
- IP information
- IGMP multicast group information
- IGMP multicast router port information
- Link status information
- Port information
- Group information
- Information dump
- Statistics Menu
- Configuration Menu
- Introduction
- System configuration
- System host log configuration
- Secure Shell Server configuration
- RADIUS server configuration
- TACACS+ server configuration
- NTP server configuration
- System SNMP configuration
- SNMPv3 configuration
- SNMPv3 User Security Model configuration
- SNMPv3 View configuration
- SNMPv3 View-based Access Control Model configuration
- SNMPv3 Group configuration
- SNMPv3 Community Table configuration
- SNMPv3 Target Address Table configuration
- SNMPv3 Target Parameters Table configuration
- SNMPv3 Notify Table configuration
- System Access configuration
- Port configuration
- Spare Ports Group configuration
- Group configuration
- Configuration Dump
- Saving the active switch configuration
- Restoring the active switch configuration
- Operations Menu
- Boot Options Menu
- Maintenance Menu
Command Line Interface 41
Trunk group information
Command: /info/l2/trunk
Trunk group 1, Enabled
Protocol - Static
port state:
20: forwarding
21: forwarding
22: forwarding
23: forwarding
24: forwarding
When trunk groups are configured, you can view the state of each port in the various trunk groups.
Layer 3 information
Command: /info/l3
[Layer 3 Menu]
arp - ARP Information Menu
ip - Show IP information
igmp - Show IGMP Snooping Multicast Group information
dump - Dump all layer 3 information
The following table describes the Layer 3 Information Menu options.
Table 29 Layer 3 information menu options
Command Usage
arp Displays the Address Resolution Protocol (ARP) Information Menu.
ip Displays IP Information. IP information, includes:
• IP interface information: Interface number, IP address, subnet mask, VLAN number, and
operational status.
• Default gateway information: Metric for selecting which configured gateway to use,
gateway number, IP address, and health status
• IP forwarding information: Enable status, lnet and lmask
• Port status
igmp Displays IGMP Information Menu.
dump Dumps all switch information available from the Layer 3 Menu (10K or more, depending on
your configuration).
If you want to capture dump data to a file, set your communication software on your
workstation to capture session data prior to issuing the dump commands.