Electronics America Switch Reference Guide
Table Of Contents
- SmartPanel
- Browser-based interface
- Command Line Interface
- Introduction
- Information Menu
- Introduction
- Menu overview
- System Information Menu
- SNMPv3 Information Menu
- System information
- Show last 100 syslog messages
- System user information
- Layer 2 information
- FDB information menu
- Trunk group information
- Layer 3 information
- ARP information
- IP information
- IGMP multicast group information
- IGMP multicast router port information
- Link status information
- Port information
- Group information
- Information dump
- Statistics Menu
- Configuration Menu
- Introduction
- System configuration
- System host log configuration
- Secure Shell Server configuration
- RADIUS server configuration
- TACACS+ server configuration
- NTP server configuration
- System SNMP configuration
- SNMPv3 configuration
- SNMPv3 User Security Model configuration
- SNMPv3 View configuration
- SNMPv3 View-based Access Control Model configuration
- SNMPv3 Group configuration
- SNMPv3 Community Table configuration
- SNMPv3 Target Address Table configuration
- SNMPv3 Target Parameters Table configuration
- SNMPv3 Notify Table configuration
- System Access configuration
- Port configuration
- Spare Ports Group configuration
- Group configuration
- Configuration Dump
- Saving the active switch configuration
- Restoring the active switch configuration
- Operations Menu
- Boot Options Menu
- Maintenance Menu
Browser-based interface 21
Time Services
On the BBI, choose System Settings > Time Services to configure the NTP server.
The following table describes the configuration.
Table 11 Time Services
Command Description
General Settings
Current Date Configures the system date.
Current Time Configures the system time using a 24-hour clock format.
Timezone Location Configures the time zone where the switch resides. You are prompted to select
your location (continent, country, region) by the timezone wizard. Once a
region is selected, the switch updates the time to reflect local changes to
Daylight Savings Time, etc.
Daylight Savings Disables or enables daylight savings time in the system clock. When enabled,
the switch will add an extra hour to the system clock so that it is consistent with
the local clock. By default, this option is disabled.
NTP Settings
Time Services Enables or disables the NTP synchronization service.
Update Internal (min) Specifies the interval, that is, how often, in minutes (1-44640), to
re-synchronize the switch clock with the NTP server.
Primary Server Configures the IP address of the primary NTP server to which you want to
synchronize the switch clock.
Secondary Server Configures the IP address of the secondary NTP server to which you want to
synchronize the switch clock.