Electronics America Switch Reference Guide
Table Of Contents
- SmartPanel
- Browser-based interface
- Command Line Interface
- Introduction
- Information Menu
- Introduction
- Menu overview
- System Information Menu
- SNMPv3 Information Menu
- System information
- Show last 100 syslog messages
- System user information
- Layer 2 information
- FDB information menu
- Trunk group information
- Layer 3 information
- ARP information
- IP information
- IGMP multicast group information
- IGMP multicast router port information
- Link status information
- Port information
- Group information
- Information dump
- Statistics Menu
- Configuration Menu
- Introduction
- System configuration
- System host log configuration
- Secure Shell Server configuration
- RADIUS server configuration
- TACACS+ server configuration
- NTP server configuration
- System SNMP configuration
- SNMPv3 configuration
- SNMPv3 User Security Model configuration
- SNMPv3 View configuration
- SNMPv3 View-based Access Control Model configuration
- SNMPv3 Group configuration
- SNMPv3 Community Table configuration
- SNMPv3 Target Address Table configuration
- SNMPv3 Target Parameters Table configuration
- SNMPv3 Notify Table configuration
- System Access configuration
- Port configuration
- Spare Ports Group configuration
- Group configuration
- Configuration Dump
- Saving the active switch configuration
- Restoring the active switch configuration
- Operations Menu
- Boot Options Menu
- Maintenance Menu
Browser-based interface 20
Remote User Administration
On the BBI, choose System Settings > Remote User Administration to configure the RADIUS server or the
TACACS+ server.
The following table describes the configuration.
Table 10 Remote User Administration
Command Description
Radius
Radius disable/enable Enables or disables the Radius server.
Port Configures the number of the UDP port to be configured, between 1500 - 3000.
The default is 1645.
Radius Primary Server Configures the primary Radius server address.
Radius Secret for Primary Server Defines the shared secret (up to 32 characters) between the switch and the
RADIUS server(s).
Radius Secondary Server Configures the secondary Radius server address.
Radius Secret for Secondary Server Defines the secondary shared secret (up to 32 characters) between the switch
and the Radius server(s).
Tacacs+
Tacacs+ disable/enable Enables or disables the Tacacs+ server.
Port Configures the number of the TCP port to be configured, between 1 and
65000. The default is 49.
Tacacs+ Primary Server Configures the primary TACACS+ server address.
Tacacs+ Secret for Primary Server Configures the shared secret (up to 32 characters) between the switch and the
TACACS+ server.
Tacacs+ Secondary Server Configures the secondary TACACS+ server address.
Tacacs+ Secret for Secondary Server Configures the secondary shared secret (up to 32 characters) between the
switch and the TACACS+ server.