Electronics America Switch Reference Guide
Table Of Contents
- SmartPanel
- Browser-based interface
- Command Line Interface
- Introduction
- Information Menu
- Introduction
- Menu overview
- System Information Menu
- SNMPv3 Information Menu
- System information
- Show last 100 syslog messages
- System user information
- Layer 2 information
- FDB information menu
- Trunk group information
- Layer 3 information
- ARP information
- IP information
- IGMP multicast group information
- IGMP multicast router port information
- Link status information
- Port information
- Group information
- Information dump
- Statistics Menu
- Configuration Menu
- Introduction
- System configuration
- System host log configuration
- Secure Shell Server configuration
- RADIUS server configuration
- TACACS+ server configuration
- NTP server configuration
- System SNMP configuration
- SNMPv3 configuration
- SNMPv3 User Security Model configuration
- SNMPv3 View configuration
- SNMPv3 View-based Access Control Model configuration
- SNMPv3 Group configuration
- SNMPv3 Community Table configuration
- SNMPv3 Target Address Table configuration
- SNMPv3 Target Parameters Table configuration
- SNMPv3 Notify Table configuration
- System Access configuration
- Port configuration
- Spare Ports Group configuration
- Group configuration
- Configuration Dump
- Saving the active switch configuration
- Restoring the active switch configuration
- Operations Menu
- Boot Options Menu
- Maintenance Menu
Browser-based interface 18
3. Select the corresponding radio button to assign the VLAN to a Port Group.
4. Click Apply to make the changes active.
Management
On the BBI, choose System Settings > Management to configure SNMP System Settings and System Log Server
Settings.
The following table describes the management configuration.
Table 8 Management
Command Description
SNMP System Settings
System Name Configures the name for the system. The name can have a maximum of 64
characters.
System Contact Configures the name of the system contact. The contact can have a maximum
of 64 characters.
System Location Configures the name of the system location. The location can have a maximum
of 64 characters.
System Log Server Settings
IP Address of Primary Server Sets the IP address of the primary syslog server.
Severity of Primary Server This option sets the severity level of the primary syslog server displayed. The
default is 7, which means log all the seven severity levels.
Facility of Primary Server This option sets the facility level of the primary syslog server displayed. The
default is 0.
IP Address of Secondary Server Sets the IP address of the secondary syslog server.
Severity of Secondary Server This option sets the severity level of the secondary syslog server displayed.
The default is 7, which means, log all seven severity levels.