Electronics America Switch Reference Guide
Table Of Contents
- SmartPanel
- Browser-based interface
- Command Line Interface
- Introduction
- Information Menu
- Introduction
- Menu overview
- System Information Menu
- SNMPv3 Information Menu
- System information
- Show last 100 syslog messages
- System user information
- Layer 2 information
- FDB information menu
- Trunk group information
- Layer 3 information
- ARP information
- IP information
- IGMP multicast group information
- IGMP multicast router port information
- Link status information
- Port information
- Group information
- Information dump
- Statistics Menu
- Configuration Menu
- Introduction
- System configuration
- System host log configuration
- Secure Shell Server configuration
- RADIUS server configuration
- TACACS+ server configuration
- NTP server configuration
- System SNMP configuration
- SNMPv3 configuration
- SNMPv3 User Security Model configuration
- SNMPv3 View configuration
- SNMPv3 View-based Access Control Model configuration
- SNMPv3 Group configuration
- SNMPv3 Community Table configuration
- SNMPv3 Target Address Table configuration
- SNMPv3 Target Parameters Table configuration
- SNMPv3 Notify Table configuration
- System Access configuration
- Port configuration
- Spare Ports Group configuration
- Group configuration
- Configuration Dump
- Saving the active switch configuration
- Restoring the active switch configuration
- Operations Menu
- Boot Options Menu
- Maintenance Menu
Browser-based interface 15
External Port Settings
On the BBI, choose External Port Settings to configure the external port.
The following table describes the external port configuration.
Table 7 External Port Settings
Command Description
Port Name Sets a name for the port. The assigned port name appears next to the port
number on some information and statistics screens.
Switch Port State Enables or disables the port.
Link configuration Sets the link speed. The choices include:
• Auto Negotiation Speed and Duplex (default)
• 1Gbps / Full Duplex
• 100Mbps / Full Duplex
• 10Mbps / Full Duplex
Flow Control Sets the flow control. The choices include:
• Rx: Receive flow control
• Tx: Transmit flow control
• both: Receive and transmit flow control (default)
• none: No flow control