User Guide

English
English-13
Specifications
Monitor Specifications MultiSync LCD2070WNX Monitor Notes
LCD Module Diagonal: 51.1 cm/20.1 inches Active matrix; thin film transistor (TFT)
Viewable Image Size: 51.1 cm/20.1 inches liquid crystal display (LCD); 0.258 mm dot
Native Resolution (Pixel Count): 1680 x 1050 pitch; 300 cd/m
2
white luminance; 500:1
contrast ratio, typical.
Input Signal Video: ANALOG 0.7 Vp-p/75 Ohms Digital Input: DVI-D
Sync: Separate sync.TTL Level Positive/Negative
Horizontal sync. Positive/Negative
Vertical sync. Positive/Negative
Composite sync. Positive/Negative*
2
Sync on Green (Video 0.7 Vp-p and Sync. Negative 0.3 Vp-p)*
2
Display Colours 16,194,277 Depends on display card used.
Synchronization Range Horizontal: 31.5 kHz to 82.3 kHz Automatically
Vertical: 56.0 Hz to 75.0 Hz Automatically
Viewing Angle Left/Right: 80°/80° (CR > 5)
Up/Down: 75°/70° (CR > 5)
Resolutions Supported 720 x 400*
1
: VGA text Some systems may not support all modes
640 x 480*
1
at 60 Hz to 75 Hz listed.
800 x 600*
1
at 56 Hz to 75 Hz
832 x 624*
1
at 75 Hz
1024 x 768*
1
at 60 Hz to 75 Hz
1152 x 864*
1
at 75 Hz
1152 x 870*
1
at 75 Hz
1280 x 960*
1
at 60 Hz to 75 Hz
1280 x 1024*
1
at 60 Hz to 75 Hz
1440 x 900*
1
at 60 Hz Recommended resolution is 60 Hz for
1680 x 1050 at 60 Hz.................................. optimal display performance.
Active Display Area Horizontal: 433.0 mm/17.0 inches
Vertical: 271.0 mm/10.7 inches
USB Hub I/P: USB Specification Revision 2.0
Port: Upstream 1
Downstream 4
Load Current: Maximum 0.5A per port
Power Supply AC 100-240V ~ 50/60Hz
Power Consumption 74 W (typ)
(without optional Sound Bar)
Current Rating 1.3 - 0.7 A
Dimensions 471.4 mm (W) x 371.3 - 481.3 mm (H) x 220.0 mm (D)
18.6 inches (W) x 14.6 - 18.9 inches (H) x 8.7 inches (D)
Weight 8.5 kg (18.7 lbs)
Environmental Considerations
Operating Temperature: 5°C to 35°C/41°F to 95°F
Humidity: 30% to 80%
Altitude: 0 to 10,000 Feet
Storage Temperature: -10°C to 60°C/14°F to 140°F
Humidity: 10% to 85%
Altitude: 0 to 30,000 Feet
*1 Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear different. This is
normal and necessary for all current flat panel technologies when displaying non-native resolutions full screen. In flat panel technologies, each dot on
the screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.
*2 If your display is not showing a picture of the SOG and Composite Sync. Signal, please contact our hotline for further assistance.
NOTE: Technical specifications are subject to change without notice.