User's Guide
36 | NEC MULTIPROFILER - USER’S GUIDE
Select Custom type adjustment wizard page
The Select Custom type page is shown when Custom Picture Mode is selected in the rst wizard page, and is used
to select the type of Custom Picture Mode. These modes allow a custom name to be entered for easy identication.
The Custom Picture Mode can be used for three different ways.
These are:
• Full Custom - In this mode, custom values and settings can be created for the Gamma, White Point, Color
Gamut, Brightness and Black Level. The functionality of this mode is exactly the same as the Full Picture Mode,
with the addition that it can be given a custom name.
• Emulate another display - In this mode, the monitor can be made to emulate another monitor by using the
ICC/ColorSync prole of that monitor to set the Gamma, White Point, Color Gamut, and Brightness. This can
be useful for applications in which the monitor needs to emulate the color characteristics of another type for
legacy purposes.
• Print Emulation - In this mode, the monitor can emulate the output of a printer by using the ICC/ColorSync
prole for the printer to create a 3D LUT (Look-Up-Table) in the monitor. This is useful for use with applications
that do not offer print previews or softproong of a printer. This mode is normally used together with a normal
(non-3D LUT) Picture Mode to switch between normal and print emulation views using MulitProler or the OSD
(On Screen Display) controls.
Note: The Print Emulation function is not available on the Linux version of MultiProler.
The wizard pages that follow will
depend on the mode selected on
this page.