Server User's Guide

4-14 Upgrading Your System
Removing and Installing the Cooling Baffle
If your system has a cooling baffle, remove and install it as follows.
1.
Remove the cooling baffle as follows.
!
Locate the two fans inside the chassis, at the rear of the chassis.
!
Remove four screws (two from each fan) from the fans, as shown in the
following figure.
!
Remove the baffle.
2.
Install the cooling baffle as follows.
!
Align the baffle mounting holes with the fan mounting holes.
!
Fasten the baffle in place with the four fan mounting screws.
!
Replace the left side panel, plug in the power cords, and power up the
system.
!
Run the BIOS Setup utility (press
F2
at the startup screen) to configure
your system’s speed.
A
– Screws
B
– Baffle
Removing/Installing the Cooling Baffle
Note:
The cooling baffle must be removed if you are
adding or removing DIMMs or if you are adding or replacing
processors.