User's Guide

1. Installing Internal Optional Devices
Express5800/R120f-2M User’s Guide
106
Chapter 2 Preparations
6. Slowly close the handle.
The tray is locked making a clicking sound.
Note
When you push the drive into the slot, confirm the handle got hooked on the
frame.
7. Run BIOS Setup Utility, and then specify the boot order from Boot menu.
For details, see Chapter 2 (1. System BIOS) in "Maintenance Guide"
Tips
The saved boot order is cleared when a hard disk drive is added.
1.25.2
Removal
To remove hard disk drive, reverse the installation procedure.
If you transfer or dispose of the removed hard disk drive, see Chapter 1 (1. Transfer, Relocation, and Disposal)
in “Maintenance Guide” to erase data.
Important
NEC assumes no liability for data leakage should the produc
t be
transferred to a third party without erasing the data.
Note
• If you remove a hard disk drive due to a failure, check the slot with its lower
DISK LED lit in amber.
• Do not hold handle to pull the drive out. Doing so may damage the handle.
Run the BIOS Setup Utility, and then specify the boot order from Boot menu.
For details, see Chapter 2 (1. System BIOS) in "Maintenance Guide".
Tips
The saved boot order is cleared when a hard disk drive is added.
DISK LED 1 (upper)
DISK LED 2 (lower)