Regulatory and Safety Notices

Plug in to a proper power source.
Use a grounded outlet with the specified voltage. Use of an outlet with a voltage other than that
specified causes fire and electrical leakage.
Do not install the server in any environment that requires an extension cord. Connecting to a
cord that does not conform to the power supply specs of the server causes overheating, resulting
in fire.
Do not connect many power cords into a single outlet by using extension cords.
The electric current exceeding the rated flow overheats the outlet, which may cause a fire.
Insert the power plug into the outlet as far as it goes.
Heat generation resulting from a halfway inserted power plug (imperfect contact) may cause a
fire. Heat will also be generated if condensation is formed on dusty blades of the halfway
inserted plug, increasing the possibility of fire.
Do not use any unauthorized power cord.
Use only the power cords provided with the server. Electric current that exceeds the amount
allowed could cause fire. Also, observe the following precautions to prevent electrical shock or
fire caused by a damaged power cord.
•
Do not stretch the cord harness
•
Do not bend the power cord.
•
Do not twist the power cord
•
Do not step on the power cord.
•
Uncoil the power cord before use
•
Do not secure the power cord with staples or equivalents
•
Do not pinch the power cord
•
Keep chemicals away from the power cord
•
Do not place any object on the power cord
•
Do not alter, modify, or repair the power cord
•
Do not use a damaged power cord. Replace the damaged power cord with a power cord of
the same standard. Contact your sales representative for replacement.
Do not use the attached power cord for any other devices or usage.
The power cord that comes with your server is designed aiming to connect with this server and
to use with the server, and its safety has been tested. Do not use the attached power cord for any
other purpose. Doing so may cause a fire or an electric shock.
Do not unplug the power cord by holding the cable part.
Pull the power cord straight out by holding the plug. Pulling the power cord by holding the
cable part or applying extra pressure to the connector may damage the cable part, which may
cause a fire or electric shock.
Multiple power sources
Disconnect all power supply cords before servicing.
Chapter 1. Precautions for Use (EN)
5