Installation Guide

6. Setting Up Windows Server 2008
Express5800/R120f-1M, R120f-2M Installation Guide (Windows)
293
Chapter 1 Installing Windows
6.5.3
Setting up team/LiveLink (BACS)
This section describes procedures for creating and deleting team, and for configuring LiveLink.
The supported network adapters are as follows:
• Network adapters for the standard configuration: (N8104-154/156)
• Optional LAN boards: (N8104-149/150/151/152)
Note
• For how to delete an adapter team, refer to Chapter 1 (6
.5.3 Setting up
team/LiveLink (BACS) - (4) Procedure for deleting team).
Check the following points when deleting an adapter team.
−
When replacing the motherboard or optional LAN boards after an adapter
team is configured, delete the adapter team first.
−
If a team exists, delete the team first. If the team is bound to a Hyper-V virtual
adapter, unbind the Hyper-V adapter before deleting the team.
•
Be sure to specify the same Jumbo Mtu (Jumbo Packet) setting to all the
adapters that compose a team.
• Do not configure the teams with adapters that use the iSCSI function.
(1) Team type and LiveLink
The following team types are supported.
• Smart Load Balancing and Failover (without Standby Member)
• Smart Load Balancing (Auto-Failback Disable) (with Standby Member)
• FEC/GEC Generic Trunking