User Guide

- 22-
Login/Logout information and operation log are displayed.
5 Statistics Information
The Power Graph which shows power consumption changes of latest 10 minutes or 24
hours are displayed.
6 Video Record Information(*)
If the automatic video recording function is enabled from configuration tab, the video
records which were recorded at the time of BIOS POST or OS stall are displayed. Also
you can playback or download or delete them.
(*) The video length is maximum 5 minutes but it might be shorter than 5 minutes depending
on the size limit of regions of video record data or the size of the resolution of screen to be
recorded.
Notice
If the hardware clock setting (RTC) is set by the host system OS to
the time in UTC offset, The timestamp of SEL (System Event Log) will
be set to the time in UTC offset instead of local timestamp. Please
notice that the time difference between UTC time and local time will
occur.
Notice
When the AC power of the host system is turned off, the video record
data that was saved by the automatic video recording function will be
erased.
Notice
The video record data during BIOS POST will be overwritten at next
collection time. On the other hand, the video record data during OS
stall will be saved and not be collected at next collection time until it
is deleted manually.
Notice
If the automatic video recording is run opening the Remote
KVM/Media, the video record data on the playback screen might be
displayed broken very rarely. In this case, please run the automatic
video recording without opening the Remote KVM/Media.
Notice
If the host system power on by the AC-LINK with the automatic video
recording is enabled, the video record data during BIOS POST might
not be collected even if the AC-LINK delay time to the DC ON is short.
In this case, please set the AC-LINK delay time to 65 seconds or more
(recommends 70 seconds or more).