User's Manual

17
♦ To change the settings of SNMP Service
1. Double-click [Services] at [Administrative Tools] in [Control Panel].
2. Click [SNMP Service] from the service list and then [Properties] in [Action] menu.
"SNMP Properties" dialog box appears.
Tips
● When a list of Windows service is opened when installing SNMP Service,
[Traps] property sheet,[Agent] property sheet and [Security] property sheet of
"SNMP Properties" dialog box are not indicated. When a property is not
indicated right, close a list of Windows service and open a list of Windows
service again.
● When not installing Feature Administration Tools of SNMP Service, "SNMP
Properties" dialog box is not indicated right in Windows Server 2012. Add
[SNMP Tool] from [Control Panel] [Programs and Features] - [Turn Windows
features on or off] - [Features] - [Remote Server Administration Tools] -
[Feature Administration Tools].
3. Enter "public" or an arbitrary name in [Community name] box of [Traps] property sheet
and click [Add to list].
To change the community name of traps to be received from the default "*" in NEC ESMPRO
Manager side, enter the same name as the community name newly set in NEC ESMPRO
Manager site.
To receive trap from NEC ESMPRO ServerAgentService at NEC ESMPRO Manager, both
community names must be the same.
4. Click [Add].
5. Click [Add...] in [Trap destinations]. After entering IP address of NEC ESMPRO
Manager machine of the send destination in [Host name, IP or IPX address] box, click
[Add].
When a designated IP address (or host name) is designated by setting of Manager Alert
(TCP/IP) in the trap destination, the message to warn to overlap is indicated.
The alert overlaps by this setting, and is reported to NEC ESMPRO manager of a designated IP
address (or host name).
6. Click [OK] Terminate the network setup.