User's Manual

16
Settings of SNMP Service
1.2.4
At all except for server core installation,"♦ Setting preparation of SNMP Service" is unnecessary.
Follow the procedure of the next "♦ To change the settings of SNMP Service".
♦ Setting preparation of SNMP Service
The setting change of SNMP Service of the server that executes, Server Core installation is done from
PC for Management by way of the network.
1. Connected preparation is done on the server side.
Execute the following commands by the command prompt on the server side.
"netsh advfirewall firewall set rule group="File and Printer Sharing" new enable=Yes"
2. Install SNMP Service on PC for Management.
*Operation by "PC for Management" after.
About the method of installing SNMP Service, see "1.2.3 Installing SNMP Service".
3. The session from PC for Management to the server is established.
Execute the following commands by the command prompt on PC for Management side.
"Net use * ¥¥ <ServerName> ¥c$ /u: <UserName>"
Tips
● ServerName is a name of the server that executes Server Core installation.
● UserName is a name of Administrative account.
4. Click "Computer Management" in "Administrative Tools".
5. Right-click on the tree of the left pane, and click "Connect to another PC…"
6. The computer name of the server that executes Server Core installation is input to
"Select Computer" box, and click "OK".
Connected to "Computer Management" of the server that executes Server Core installation.