Installation Guide

45
4. In [ToolYYY] section (YYY is any of the sequence number from ˝001 to 999˝),
specify individual log command.
- In ˝Command˝, specify the absolute path of log command.
- In ˝Directory˝, specify the absolute path where the log-gathering command is executed.
- In ˝LogFile˝, specify the absolute path.
- When a folder is specified, the all files under it (includes subfolders) are collected. Specify
the events as ˝SourceNameXX˝, ˝EventIDXX˝ (˝XX˝ is any of the sequence number from
˝01 to 99˝).
- In ˝SourceNameXX˝, specify the source name of the target. When ˝*˝ is given, all source
name are specified.
- In ˝EventIDXX˝, specify the target event ID. Specify the event ID, all 32 bytes events, in
hexadecimal beginning with ˝0x˝. Multiple event IDs can be given, separated by ˝,˝. When
˝*˝ is given, all event IDs are specified.
- In ˝IPadr˝, when IP address of the server in which failure occurred is passed to commands
as parameters, select [Yes]. When IP address is not passed, specify ˝NO˝ or do not enter
IPadr.
* Concerning the event that corresponds with multiple [ToolYYY], all collecting
commands are executed. In this case, Timeout is applied to the session until after all
command execution is completed. Each collection command is not applicable.
* When no command is written in [DefaultTools] section, log-gathering is executed
concerning only the event defined in [ToolYYY].
* Even if ˝*˝ is defined in [NoneTrouble] section, log collection of [ToolYYY] section log
is executed concerning the event written in [ToolYYY] section.