Installation Guide

aged server is power

e keyed in from the remote console or the keyed data display may be

al Redirection function

nd so on) or the software

erminal and so on) cannot control.

UI remote console via LAN, set

system, and then boot

gement, you cannot put

tting".

r Cap value.

by lowering the frequency of CPU

e electric power value does not fall any more.

♦ In case of key-in failure on the remote console

 During DOS boot or access to the removable media immediately after the man

switch is turned ON, data cannot b

delayed.

 Remote Console is realized by using SOL function of IPMI conformity and the Seri

of BIOS.

Data cannot be keyed in from the remote console when the firmware (BIOS a

requires the key code that VT100 terminal emulator (the hyper-t

Refer to the document of each firmware or software for the details.

♦ RAID EzAssist Configuration Utility

To operate RAID EzAssist for a SOL-incompatible managed server from C

the item "Console Redirection" to "Disable" on BIOS Setup Utility screen, reboot the

RAID EzAssist Configuration Utility.

♦ Power management

 If you set the value on the managed server which does not support power mana

back the value to "unsetting". Set "zero" to each value, it is accepted as "unse

 The electric power value might not necessarily reach even the value of Powe

The electric power control lowers the power consumption of the system

/ Memory.

When CPU / Memory Throttling value reaches 100%, th

Note

For more detail about Power Monitoring and Power Control Function, reference the following site.

http://www.58support.nec.co.jp/global/download/index.html

[Others] - [Technology paper]

♦ CPU blade auto registration

ou can execute "Check

dress is set from a CPU blade to another CPU blade during "CPU blade auto registration"

tion"), NEC ESMPRO

ger may not be able to connect CPU blade because old information remains in ARP table on PC for

Management. Wait for a few minutes and try "Check Connection".

When "Check Connection" of "CPU blade auto registration" was failed. Y

Connection" on "Server Properties" - "Connection Setting".

If a specified IP ad

process (ex. when you replace CPU blade and execute "CPU blade auto registra

Mana