Installation Guide

3. Setting Up Windows Server 2012
Express5800/R120e-1M, R120e-2M Installation Guide (Windows)
68
Chapter 1 Installing Windows
9. Proceed with the following procedure according to the installation type.
Tips
During setup, a virtual floppy disk drive is temporarily connected. Follow the
instructions below to reference the virtual floppy disk drive.
Server with a GUI
Click app_pkg.bat of the virtual floppy disk drive (usually A: drive).
Server Core installations
(1) Type the following command at the command prompt, and then specify the drive letter of
the virtual foppy disk drive (usually A: drive).
Cd /d A:\
C:\Users\administrator>cd /d A:\
(2) Type the following, and then press <Enter> key.
app_pkg.bat
A:\>app_pkg.bat
Wait until the file copy is complete. (About 1-3minute(s))
On the server with GUI, the following progress message appears while the Starter Pack is installed.
10. Read the message, and then click OK.
Starter Pack installation starts.
Wait until the installation of the Starter Pack is complete. (About 3-5 minutes)
Note
The screen will black out instantaneously or resolution will change while Starter
Pack is installed.