Installation Guide

6. Setup for Solving Problems
Express5800/R120e-1M, R120e-2M Installation Guide (Windows)
245
Chapter 1 Installing Windows
7. In Virtual memory, click Change.
8. Clear the Automatically manage paging file size for all drives check box, and then click Custom
size.
9. In Paging file size for each drive, specify as follows:
For the Initial size text box, type a value equal to or greater than the Recommended value shown in
Total paging file size for all drives.
For the Maximum size text box, type a value equal to or greater than the value specified in Initial size.
After specifying the above values, click Set.
Note the following when specifying a paging file size.
• The above paging file sizes are recommended for collecting debug information (dump file).
The initial size of the boot volume paging file must be large enough to store dump files.
Make sure to set a sufficient paging file size. If the paging file size is insufficient, correct
debug information cannot be collected due to a shortage of virtual memory.
• For details about the Recommended value in the Total paging file size for all drives area,
see System partition size in Before Starting Setup.
• When DIMM is added, re-specify the paging file according to the increased memory size.
10. Click OK.
The message to restart the system appears depending on the modifications made.
In this case, restart the system.
Specification of the memory dump settings is now complete.