Installation Guide

4. Setting Up Windows Server 2008 R2
Express5800/R120e-1M, R120e-2M Installation Guide (Windows)
137
Chapter 1 Installing Windows
4. Click the [Configure] button on the Click the button to configure.
The Hardware and Resource Configuration Wizard appears.
5. Remove a checkmark from [iSCSI] under Protocols, if checked.
Select [Next], and then click the [Apply] button.
6. When the following message appears, select [Yes].
7. Complete steps 2 to 6 for each N8104-128 network adapter.
Then, close the Broadcom Advanced Control Suite.
8. Restart the system.
Setup is now completed.
(3) Using N8104-132/133/138
Using N8104-132/133/138 with the server, follow the procedure below to set it.
1. Insert EXPRESSBUILDER DVD into the optical disk drive.
If Autorun Menu appears, close the menu.
Tips
EXPRESSBUILDER DVD is unnecessary if Starter Pack was installed from
Internal Flash Memory. Proceed to the next step.
2. Double-click pgdyavd_disable.vbs in the following folder.
• When using EXPRESSBUILDER DVD:
EXPRESSBUILDER DVD:\002\win\winnt\ws2008x64\r2\lan\bcom\WS2008x64_r2\lan
• If Starter Pack was installed from Internal Flash Memory:
System drive:\StartPKG\ws2008x64\r2\lan\bcom\ws2008x64_r2\lan
3. When the following message appears, click [OK].
Tips
The message “Action:Non” indicates that the LAN driver is already set.
4. Eject EXPRESSBUILDER DVD from the optical disk drive, and then restart the system.
Setup is now completed.
Applying the changes will temporarily interrupt the network connection.
The process may take several minutes and the connection will resume
afterwards.
Do you want to continue?
Configuration Completed
[Option:PopUp RLV Disabled(Action:Done
)]
Reboot the system